what is the difference between rake and rack.

Question Posted / rg sharma

13 Answers
18507 Views
Bhel, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is the difference between rake and rack...

Answer / siva prasad

rack is 90degrees rake is 45degree

Is This Answer Correct ?

1 Yes

2 No

what is the difference between rake and rack...

Answer / mridul

rake is 90 deg. and rack is 45 deg

Is This Answer Correct ?

3 Yes

4 No

what is the difference between rake and rack...

Answer / dharmendra

rake is 45 degre but the term rack is usedin ic engine
called common rack which is used to increase or decrease
fuel quantity

Is This Answer Correct ?

0 Yes

4 No

Post New Answer

More Mechanical Engineering Interview Questions

AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME

0 Answers

what is the difference between application of single acting actuator and double acting actuator

1 Answers H2O, Honda,

What causes turbocharger surging?

0 Answers RRB,

What are the causes of high alkalinity in boiler water?

2 Answers ABC Inc, RRB, Siemens,

what is the difference between impact force and sudden force?

4 Answers

why the tanker lowery have elliptical shape?

2 Answers ITC Infotech,

what is critical temprature discuss that is any pressure greater than critical pressure is valid for boiler design.....2 in what cycle steam power plant is based draw h-s diagram.different process to make gear what is tooth profile what is generatic and directric and many more as i m doing mtech thats why interview was of 30 minute...........

0 Answers DVC,

wat do u meant by mechanical enggg

8 Answers Texas,

i am trying to select the correct grade steel for a shaft that will have a flap on it weighing about 4.5 tons being forced up with hydraulic rams. can someone tell me what grade the shaft should be and if it should be stainless steel or not

2 Answers Rainford EMC Systems,

What is the importance of workshop?

0 Answers

Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?

0 Answers

Hi i am riyaz ahmed . i got rejected for first time and i nedd to apply for next time and can i apply in 1 or 2 week . and wt abt my sevies fee ? i should make a new once shill i go with the same and wt docement i should change can u plz help me out and my mail it is royalriyaz@gmail.com

0 Answers

For more Mechanical Engineering Interview Questions Click Here