Arrange the efficiency of the engine in decreasing order
Otto, Diesel, dual
Answers were Sorted based on User's Feedback
Answer / fisuleng09
BASED ON THE COMPRESSION RATIO THE EFFICIENCY OF
OTTO
>
DUAL
>
DIESEL
CYCLE
Is This Answer Correct ? | 19 Yes | 4 No |
Answer / aditya
the answer depends on condition
for the same pressure ratio
otto > dual > diesel
for same Q1
diesel > dual > otto
Is This Answer Correct ? | 12 Yes | 4 No |
Answer / karthick
for the same compression ratio
the efficiency of otto cycle is greater than dual and disel
cycle but dual cycle is greater than diesel cycle
otto>dual>diesel
Is This Answer Correct ? | 10 Yes | 3 No |
Answer / shatrughan kumar paswan (nit a
there are two condition.
1. for same compression ratio & same heat input
otto,dual,diesel
2. for same maximum pressure& heat supplied
diesel,dual,otto
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / rajesh
DIESEL CYCLE WOULD DEFINITELY HAVE A HIGHER COMPRESS. RATIO
THAN OTTO CYCLE,SO
DIESEL>DUAL>OTTO
Is This Answer Correct ? | 3 Yes | 3 No |
Answer / nishant
It all depends on operation condition,compression ratio,
maximum allowable temperature and pressure.
For same condition( for non-tech ppl)
Diesel< dual< otto
Is This Answer Correct ? | 3 Yes | 3 No |
Name the grade of forged steel use for manufacturing of master connecting rod and why to prefer that grade.
What is the purpose of a turning gear?
State fourier’s law of conduction.
want to know all about inerview of dmrc for je(mech.)
Why two stroke engine can’t be used in cars?
If an ID Fan is designed for a suction pressure of - 250 mm wg and discharge pressure of +150 mm wg, and it is installed in a system where the required system resistance at suction is only -50 mm wg, will the ID Fan be able to produce a discharge pressure of +350 mm wg?
What do u mean about Gear Coupling Number like 101,102,103.....110,112....and how u will get proper Number of Gear Coupling.,Explain it.
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
What are the different theories of failure under static load, explain ?
what are the essential things for the power plant
operation of flywheel
What is the difference between s.s to en8