why HT voltage rating in multiple of 11

Answers were Sorted based on User's Feedback



why HT voltage rating in multiple of 11..

Answer / ee

since the word elecrticity has 11 letters

Is This Answer Correct ?    8 Yes 53 No

why HT voltage rating in multiple of 11..

Answer / hore_aec

It is nothing but a joke.
If HT voltage rating is always in multiple with 11, then
how we get 25kV,400kV,800kV?
It is a standard of AC voltage to maintain.

Is This Answer Correct ?    29 Yes 84 No

Post New Answer

More Electrical Engineering Interview Questions

what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?

0 Answers  


WHY IN WESTERN COUNTRIES THE ELECTRIC SHOCK IS VERY SLOW AS COMPARE TO INDIA.&IF ANY ONE HAVE CORRECT KNOWLEDGE THEN SEND OTHERWISE NOT

1 Answers  


why auto transformer connected in star?

1 Answers  


iii) A shunt motor runs at 70 rad/sec from a 460V supply and takes in an armature current of 100A. Resistors of 2.52 ohms and 1.64 ohms are connected in series with the armature and in parallel with the armature respectively. The field excitation remains direct from the 460V supply but the generated torque is halved. Determine the new running speed. Neglect brush voltage drop. The armature resistance is 0.4 ohms. [15]

1 Answers  


which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?

0 Answers  






What is the differance between 2 dc motors of armature voltage 660 v and 440 v?

0 Answers   Kirloskar,


Sir We have a REF relay connected to 10MVA(Y-Y) Transformer.on External earth fault REF relay trips along with earth fault relay.The REF relay has no complant as we tested relay.Why is it happening?

3 Answers   KSEB,


What are the minimum acceptable insulation resistances of insulation of underground cable suitable for 0.440kV,11kV, 33kV and 66kV?

2 Answers  


what is phantom load, Give any example

2 Answers  


what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering

0 Answers  


Why Neutral Busbar CT & transformer neutral CT connected with phase CT in Restricted Earth Fault?

3 Answers  


why do we use LPF wattmeter not UPF in the experiment of no load and blocked rotor test of 3phase slipring induction motor?

3 Answers   Matrix,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)