Answer / shanmugam, emrill

Specific gravity of the battery should be in 1.23 to 1.26.
Its means, if its below of the mentioned gravity,we sould
add acid or above of its, we should add distilled water in
the battery.The specific gravity showing the battery cell
strength & condition while we measuring the gravity.

Answer / kundan fegade

Specific gravity of a battery 1200 To 1250

Answer / rrameshbe

Specific gravity of a battery which used in substation is
1205+_10...

Voltage of a battery is 2.1 volt

Total battery is 55...

Answer / mmd

the specific gravity depends upon battery charge
conditions.The value of specific gravity is between 1.15 to
1.25.

Answer / panks

Specific Gravity of battery is that which is used to know
the health, weakness & strength of battery.

It will be useful for us to know the conditions of battery
to which extent it can be used or usable/unusable
conditions of battery.

Answer / raju

the specific gravity of the battery shall be 1.18 to 1.20

What is the GNA & MNA in armature reaction of Dc Generator

2 Answers   Khetan,

1. Why transfomer reting in KVA and Motor in HP

11 Answers   AirIndia, Jindal, Mind Tree,

Sparking occur when a load is switched off because the circuit has high – a.) Inductance b.) Capacitance c.) Resistance d.) None

3 Answers   Ecil,

How a generator is positioned in a hydroelectric power plant?

10 Answers   Infosys,

inductance and capacitance may result in periodic reversals of the direction of energy flow,how???

1 Answers  

how can u say about the line by looking at the tower ? {voltage rating of the line}

3 Answers   BARC, London,

why the India electrical supply transmission loss is high when compare to us

0 Answers  

what is the diff. between power transformer & distribution transformer.....

5 Answers  

how many maximum nos of add on contact we shd provide on 4 no contactor

1 Answers   Accenture,

how much current will take for 1kw power. and what is the eqoutiion which is connecting with kw and A.

2 Answers  

Hello, im taking an introduction to PLC..and i'm having a hard time on creating a program for 2 lamps blinking alternately with this button characteristics: 1.) One push button (starts upon pressing) 2.) Same push button (when pressed again, will pause the system) 3.) Same push button (when pressed again, will continue the paused system) 4.) Same push button (when pressed within 2 seconds, will shut off the system) Pls..i know this is just a simple problem for you guys..

2 Answers  

what happen when dc supply is given to the transformer

9 Answers   Bhel,