what are IS code for
M20, 25, etc
Answers were Sorted based on User's Feedback
Answer / gopal chandra sahu
refer the IS 456-2000 FOR M-20, M-25,M-30 ETC
Is This Answer Correct ? | 5 Yes | 1 No |
Answer / poonam mumbarkar
M2O,M25 is grade of concrete and IS code is standardise
refferance document of" Indian Standard" for MIX DESIGN
procedure,for testing,for workability,and achived target
strength(Normally IS codes For using
456,516,2386,4031,8112,and last one is 100262).
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / jaydeep banerjee
As per IS the volume mix of concrete shoud be mix for
M20,1:1.5:3 ratio and for M25-1:1:2 ratio and after 28
days compressive strength should be more than 20N/mm2 for
M20 & 25N/mm2 for M25
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / dayanidhi balabantaray
I think IS code 456-2000 & all so with IS code 10262
7 days compressive strength is above 67%
28 days compressive strength is Fck+4
Fck=characteristic strangth
for eg. characteristic strangth is 20 N/mm2 so 20+4=24N/mm2
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / poonam kadam
M2O,M25 is grade of concrete and IS code is standardise
refferance document of" Indian Standard" for MIX DESIGN
procedure,for testing,for workability,and achived target
strength(Normally IS codes For using
456,516,2386,4031,8112,and last one is 10262).
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / prakash
ITS CONCRETE DISENGAGE MIX AND IS CODE 456-2000 TELLING
MINIMUM OF CONCRETE GRADE
Is This Answer Correct ? | 0 Yes | 0 No |
what is the procedure to clean the mivan technically?
what is the difference between GSB & WBM ?
I was once rejected for US visa in early August. But now I'm going again for interview next week. What are the chances that I will faced the same VO????
What is the maximum allowable 'Silt content' in River sand
16 Answers IVRCL, Om Buildcon,
How to calculate water cement ratio in mix desion
what is meant by velocity & gravity ?what is the difference between normal liquid flow & gravity liquid flow ?
what means if slump is less than 25mm and greater than 80mm?
What is Refuse Area ? And What is Definition ?
What is eccentricity in laymans term Can't understand bookish language .please explain in easy way.
what is the thickness mortar between two bricks
in the earthquqke the profile of water on dam is parabolic or not
polavaram project is situated inwhich place?