What is meant by Resonance what are the different types of
resonance and what are uses of them?
Answers were Sorted based on User's Feedback
Answer / archana
An electrical circuit consisting of various active and
passive sources,in such a circuit,the state in which the
current is maximum is called RESONANCE.
So the network should be purely resistive,for that the
inductive reactance and the capacitive reactance should be
equal.then Vl and Vc will be equal and they cancel
eachother as they both are 180 degrees out of phase.....
Is This Answer Correct ? | 1 Yes | 2 No |
Answer / gowri sankararao . a
In electrical circuit if the resistance offered by iductor
is exactly equal to the resistance offered by the capacitor
then there is formation of resonance .
>>>At resonance power factor offerd by the network is UNITY
types of resonance :
there are two types of resonance .those are
1. series resonance
2. parallel resonance
Is This Answer Correct ? | 0 Yes | 3 No |
Answer / jeyapandian
in resonance XL = Xc
two type:
series - current is min.Z in max.
parallel- vice versa
and the P.f = 1 bcz R=Z
Is This Answer Correct ? | 8 Yes | 13 No |
what perpose of use CT ratio in gt,st,uat
Whether 3 phase induction motorwith 100 hp capacity , Amp 160 for which sensitive earth fault relay , type CTUM 15 can be used?
Is it posssible to obtain the higher speed(3000rpm) for adiferentiallly cascaded induction motors(with 8 and 6 poles)
Three way plug point is there ,in that plug why we need earth pin is bigger than compare with phase and nutral pins?
What is the approximate value of stacking factor?
Briefing the effects of ASR and ACR of a double closed-loop speed regulating system.
During Load testing of battery charger with temporary AC Generator .When reach 70% load Generator immediately shutdown .we could not able to Recognize ,what is exactly problem .Please kindly clarify us
what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send
What is the function of the exiter in DG.
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
what is the principal of star delta starter?
why neutral wire don't shock?