Answer / sachin

in electrical eng we study circuit and in electronics we
study the diode

Answer / mohit singh yadav

electrical engineering deal with low frequency& with less
use of electron transfer
mechanism,,,,,,,,,,,,,,,,,,,,,,,,,,,while electronics
engineering is completely based on electron transfer
mechanism and used transistor...

Answer / rythm

electrical deals with electricity and electronics deals
with semiconductor devices

Answer / reddy

the control of flow of electrons is called electronics

Answer / sravan

electrical satisfies ohms law but electronics does not
satisfies ohms law

Answer / praveen

electrical deals with study of passive components such as
resistors conductors insulators while electronics deals
with study of active components eg semiconductors
diode

Answer / saraswati chandra

In electrical system we study of conductors & its low
frequency & high power supply.
In electronic system we study of semiconductor &its high
frequency & low power supply.

Answer / amresh kumar

In electrical system we study of conductors & its low
frequency & high power supply & it is transfomer a.c.
current.
In electronic system we study of semiconductor &its high
frequency & low power supply & it is control
ckt.d.c.voltage.

Answer / n.dhanasekaran

***IMPORTANT NOTICE***
---------------------
1. Electrical deals with mostly AC signals.
Electronics deals with mostly DC signals.
2. Electrical deals with mostly ANALOG signals.
Electronics deals with mostly DIGITAL signals.
3. Electrical devices are mostly TRANSFORMERS, MOTORS,
GENERATORS, STARTERS etc...
Electronic devices are mostly DIODES, TRANSISTORS,
ICs(i.e, SEMICONDUCTOR DEVICES), etc...
4. SOURCES and LOADS belongs to ELECTRICAL
SIGNAL PROCESSING DEVICES belongs to ELECTRONICS
5. RESISTOR, CAPACITOR AND INDUCTOR belongs to which
category?
6. What is the difference between AC loads and DC loads?
7. Why AC motors, AC bulbs etc... are donot operated by
DC signals? and
Why DC motors, DC bulbs etc... are donot operated by
AC signals?

Answer / nivas kandasamy

in electrical current conduction is done by both holes and
electrons.
in electronics current conduction is done by only electrons

AC voltage only create magnetic flux in coils, but in Solenoid coil how 24V DC volt create flux and pick the plunger

5 Answers  

ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture

0 Answers   Mukand,

1 sq.mm alluminum cable hou much current caraing capacity

5 Answers  

How to decide the input and output circuit breaker for a 1600kva transformer.Is there any calculation is involved.

5 Answers  

A 230V, 60W bulb when connected to 230v supply what current and power will consume, if same bulb is connected to 200v what purrent and power will consume?

3 Answers  

Why relay connected R phase and B phase.?

1 Answers  

what is the best electrical system i.e substation sytem of 11kv/.433kv for a township. if township have 300nos substation of 11kv. we have to go G.O.D.O. fuse unit or Compact Substation Unit. please reply Asap.

2 Answers  

different between highvoltage & lowvoltage source

5 Answers  

Why is it preferred to use a wattmeter(s) to measure power in three phase systems rather than using a combination of other instruments e.g. voltmeters, ammeters etc?

2 Answers  

what is meant by servo motor ? how its operating either AC or DC?

0 Answers  

the 230 value of voltage which is use in our home . is that value is rms, aerage or peack value of voltage?

5 Answers   L&T,

What is the starting current of a DC Motor?

2 Answers