Slip joints are provided in the propeller shaft a) To adjust the inclination

Slip joints are provided in the propeller shaft

a) To adjust the inclination of the propeller shaft

b) To adjust the length of the propeller shaft

c) To prevent the whirling of the propeller shaft

d) To adjust the up and down movement of the rear axle

Question Posted / mahesh1984

0 Answers
1355 Views
Backbone, Bosch, MAHINDRA, Uniparts Group, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Automobile Engineering Interview Questions

what is the formula for calculating BHP IN SI UNITS

7 Answers TATA,

How can you measure bhp?

0 Answers

why do cars have smaller tyres and bikes bigger ?

4 Answers Ford, Hero Honda,

what is d/f between frame & chasses

1 Answers Audi, CLG,

PPAP - VDA full form

2 Answers Kyungshin Industrial Motherson Ltd, Tenneco,

What is engine efficiency?

0 Answers

In a constant mesh gear box, when the right dog clutch is engaged with the gear on the right side of the main shaft, a) Direct gear is obtained b) First gear is obtained c) Second gear is obtained d) Reverse gear is obtained

0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,

Explain the reason that why the tyres are always black in colour. Is this phenomena related to the heat conduction?

0 Answers

For the second gear in a synchromesh system, the drive transfer will be through a) U1, U2, C, F2, and splines b) U1, U2, C, F1, and splines c) U1, U3, D, F3, and splines d) U1, U4, U5, E, F2, and splines

0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,

The land rover 110 defender stop because someone put water/kerosene in a fuel system,what can I do in order the to run again...

1 Answers

What is the difference between Cycle time, standard time & Critical standard time?

1 Answers DICV, Pricol,

What is Brinell's hardness test ?

0 Answers Ashok Leyland,

For more Automobile Engineering Interview Questions Click Here