Why cold water is used for Boiler Hydro test
Answer / powerplant.calculations
As the temperature increases, the hydraulic test pressure decreases
Normally 20 to 50 degree C water is used for boiler hydraulic tests
Refer below link for such questions & answers
https://www.powerplantandcalculations.com/2020/06/why-how-these-in-boilers.html
Is This Answer Correct ? | 0 Yes | 0 No |
Why reheater is not used after IP turbine.
what is turn down ratio
what are the major duties of a instrumentation engineer in a power plant.?
What will happen if id fan on boiler not functioning?.Can the Boiler run without id fan? What is the effect?
what is absolute separator, how it works, what are the types in it
what is the trip circuit supervision in an electrical meaning?
whats plant?
A 5A rewirable fuse blows when 9A flows.determine the fusing factor?
1 Answers Schneider, Student, Tata Power,
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????
what is the defenation of efficiency in the high pressor boiler? what is the formila of efficiency in the high pressor boiler?
a gas turbine have how many thermocouples?