Answer / alagu

40

Answer / aditya199307@gmail.com

CT 200/5 ratio means if 200 amps flow in primary winding then it will be show 5 amp in secondary winding according to this phenomena it will multiply the given factor and show the current on the meter display.
But if we talking about its multiplying factor then it will depend upon its meteric unit like Mwh/Kwh.
If it will be on Mwh then MF is 1
If it will be on Kwh then MF is 1000

how do you select the ct/pt rating in substation

1 Answers   Apollo, Shreem Electric Ltd, Tata Motors,

---

What is the difference between expansion joints & thermal expansion joints in Bus bar

1 Answers  

---

what is mathematical relation between ac to dc current how will convert Iac=50amp to Idc

7 Answers  

---

Why C.T secondary s2 done earthing?

4 Answers  

---

how to calculate P.F from kva only?

3 Answers  

---

---

i need to calculate high voltage line power factor daily basics but there is meter reading kwh and kvah while calculating power factor kwh/kvah formula was right. for examble there is point c=13kwh c=1.8 lag c=1.2 lead and c=14.5kvah like that i know that p.f =kwh/kvah but c=1.8lag kvarh and c=1.2lead kvarh points i dont know if u know please reply

1 Answers  

---

How would your past experience translate into success in this job?

0 Answers  

---

there is a # KVA Transformer of 11 KV/440V, in simple(not use formuia) how can you calculate it's HT & LT side current.

5 Answers   Construction, wbsedcl,

---

Frequency of rotor emf in induction motor is around A same as stator frequency B 50% C 5 % or below D 30%

1 Answers   Bhel,

---

How the Transformer oil testing is done & Why oil dielectric goes LOW & what is solution for that ??

3 Answers   NTPC,

---

In 3phase power= Root*3*v*i*cos@ What is the power in 2phase....??? and Derive it

3 Answers   Essar,

---

What is the difference between Earth and Neutral?

2 Answers  

---