can anyone send me the written test paper of Indian oil corporation ltd. My email id is pratuljakhmola@yahoo.com

0 Answers  

---

PROCESS DESIGN - EXAMPLE 21.3 : According to a heuristic of chemical engineering plant design, assume a pressure difference dP = 4 psi for each 10-ft rise in elevation. A pump is needed to pump liquid from a storage tank at a lower elevation to a heating tank at a higher elevation with the elevation difference of 60 ft. (a) Find the pressure loss due to such elevation. (b) If the required minimum inlet pressure to the heating tank is 9 psi, with 1 control valve is installed between pump and heating tank, what is the dP minimum required for the control valve and the entrance to the heating tank when the heuristic mentions that at least 10 psi is required for the control valve? (c) The pressure at the inlet of the pump is 8 psi and the flowrate of the liquid produces pressure head of 50 psi. What is the total pressure produced by the pump? (d) Assume a pipeline dP of 2 psi / 100 ft for liquid flow in a pipe according to heuristic, what is the approximate maximum length of the pipe in ft that can be installed between the pump and the heating tank?

1 Answers  

---

ENGINEERING NUMERICAL METHODS - EXAMPLE 19.2 : For a mixture of benzene (B), toluene (T) and xylene (X), the equation applies where x for B, T and X will sum up to 1. The equation of x for each component is x = (L / V + 1) (F) / (L / V + K). The data of F for each component are : 0.5 for B, 0.35 for T, 0.15 for X. The data of K for each component are : 1.98 for B, 0.76 for T, 0.24 for X. When x for B + x for T + x for X = 1, find the values of (a) L / V; (b) x for each component of B, T, X respectively. You may use Excel program - Data : What-If-Analysis for Goal Seek to perform the iterative calculations.

1 Answers  

---

ENGINEERING MECHANIC - EXAMPLE 15.2 : A cantilever beam of length L = 3 m carries a uniformly distributed load (UDL) of W = 20 N / m throughout the length. Calculate the bending moment, BM of the beam near the fixed end. What is the shear force, SF at this point? Let SF = -WL, BM = -LWL/2.

1 Answers  

---

can anybody give me syallbus of chemical engineering for section engineer in railway.

0 Answers   CCIL,

---

What is the ignition temp. of Aluminum,Coper&Iron.

0 Answers  

---

What are some common causes of control valve noise?

0 Answers  

---

What is a good device to use for obtaining viscosity data for a non-newtonian fluid?

0 Answers  

---

hi i need cpcl written exam question papers if anybody pls help me

0 Answers  

---

How to calculate the release flowrates from pressurized gas systems?

1 Answers   Reliance,

---

what is flooding in a column.How do you know flooding has occured?

2 Answers   Cairn,

---

plz send me hpcl and reliance entrance test papers on my id s,kumar_bk@yahoo.co.in

1 Answers   Reliance,

---