what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
No Answer is Posted For this Question
Be the First to Post Answer
what is relation of rpm with Power supply? rpm directly Proposational to power ?
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
the input mechanical power of a single alternator is increased,its RPM increased but in case of an alternator synchronised with grid its RPM does not increased with increase of input mechanical power. why?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
What is different bewteen low or high impedance busbar protection scheme
What is the importance of quality factor in resonance?
Find active & Reactive Power transmitted in a transmisston line having Vs30 degree(sending end) to Vr(zero degree)at receving end with line inductance X ohm. Vs(30degree)-------------------Vr(zero degree) X ohm
Can I parallel 1 MVA generator with 1kVA Generator? if V, F, Ph Seq and Ph angles are same
what are the stresses in circuit breakers ?
Is it possible to measure the voltage of a battery from a single terminal?
A separately excited dc motor having 2 ohm armature resistsance draws a current of 10A and torque developed is 20 Nm under rated field condtion. the speed of the motor under the rated field condtion , when it is connected to a 100V DC source and delivering 10Nm torque....
In the UVR(Under Voltage Relay) there is a knob for the hysteresis setting. what is this setting? its threshold is given from 5% to 50%. please help me....