what is principle of DG
Answers were Sorted based on User's Feedback
Answer / geeparthi
dg means diesal generator.accroding to the farayday law and
lens law are used to the power production.
dg means couple of primover (engine)and alternator. when
engine rotates,rated rpm that time alternator produced
rated power
Is This Answer Correct ? | 14 Yes | 4 No |
Answer / geeparthi
when flux cut the comnductor or conductor cut the flux..emf
induced...
Is This Answer Correct ? | 8 Yes | 3 No |
Answer / daljit singh saini
whenever any conductor is made to rotate in the rotating
manetic field the emf induced in the conductor
Is This Answer Correct ? | 6 Yes | 1 No |
Classify the different types of load.
What is servo motor? what is its purpose?
When induction motor is started,we see all other electrial appliances connected on the same supply are dimmed out for some moment why?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
difference between torque mode and speed mode
the transient state stability limit of a system wherin power is transmitted throgh a double transmission line is (a)equal to steady state stability limit (b)more than its steady state stability limit (c)less than than its steady state stability limit (d)equal to its dynamic stability limit
Why only 1 CVT in Y-phase is used for synchronization in 3 phase power system?
what happenes if the core of the transformer saturates?
how to find motor contactor rating and bimetalic relay rating? of 30kw motor which will operate on star-delta starter?
A three phase load, around 4 km away from the 11/0.433KV distribution transformer (Neutral of Transformer is solidily earthed) and consisting of mainly very costly and sensitive electronic equipments is giving trouble due to high voltage difference between neutral and body earth. Whether this problem can addressed by connecting neutral at the load point solidly to earth?
WHAT IS THE DIFFERENCE BETWEEN SHOP DRAWINGS/ DESIGN DRAWINGS AND AS BUILT DRAWINGS??
2 Answers ACC, Al-Jaber, Dubai Group, ECEC,