Answer / abhishek chourey

DP transmitter can be calibrate by two type 1st loop & 2nd isolate in both calibration we need pressure calibrator that should be calibrate by authorized laboratory.

loop calibration:- in this calibration pressure apply to DP transmitter set the pressure on Calibrator and check on display of DP transmitter.

Isolation Calibration:- output measure in form of 4-20 mA and calculate 4-20 with respect to full range of Instrument.

Answer / santosh kumar

High side presser and low side atmosphere then callibeat transmitter.

How to work temperature gauge?

0 Answers   KJS,

---

why we are using pnp npn for sensors is there any other type?

1 Answers   CGL,

---

How to find out the current of two motors having same power consumption but different RPM?

0 Answers  

---

1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?

3 Answers   EI Electrotechnical Institute,

---

WHAT REASEAN USE TRANSMETER TWO WIRE & FOUR WIRE

5 Answers   Kentz,

---

---

which instrument is most commonly used to observe the external features of a grasshopper's abdomen?

1 Answers  

---

Which type of diagphram use in costic line,DM water line,natural gas line,oil line?

0 Answers   Hindustan Zinc,

---

as an instrumentation engineer which are the things we have to know / or we must have idea about that....

2 Answers  

---

Why 4ma - 20ma signal used in instrumentation??

5 Answers  

---

defffrence between instruments and instrumentation

8 Answers  

---

what is cems analyzer explain with principle and drawing ?

0 Answers  

---

give me all the details about the interview and which type of question being asked

0 Answers   Jindal,

---