Witch type cable use for rtd ,why?
Answers were Sorted based on User's Feedback
Answer / nishat
We use traid cable because of low resistance of cable so to get accurate output resistance and accurate temperature
Is This Answer Correct ? | 9 Yes | 0 No |
Answer / shivanand hedgapure
nickel,platinum,copper,balco,tungsten.because these are good conductors
Is This Answer Correct ? | 2 Yes | 7 No |
how to make a calliberation for deffirential pressure
what is the differnce betweeen hart and smart tx
can u guys tell me why we are using sheild in junction bos wiring ~! ?
y v r connecting 250 ohms resistor in series when u cummunicate with BT in bench calibration?
generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?
How servomotor controls throttle valve of TURBINE?
what is difference between hart signal and analog signal (4 to 20 ma)
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
0 Answers Process Control Technologies,
What is Burnout feature in a recorder?
If I want to buy a pressure switch & 3-way valve for hot water application then witch parameter I should consider.
What is difference between reset and initialization in industrial automation?
how to install the Ph and Conductivity analyser? is there are any procedures which has to be maintained.