how we control the magnitude of a generator output

Question Posted / maaz

2 Answers
3444 Views
EESINT, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how we control the magnitude of a generator output..

Answer / ajay jethwa

we can controll the output voltage of generator by changing the exitation...
if we want higher generator output voltage than we have to give more exitation.& vise versa
For frequency control prime mover speed us to be change

Is This Answer Correct ?

4 Yes

0 No

how we control the magnitude of a generator output..

Answer / k.prakashchandra

By controlling input to prime mover

Is This Answer Correct ?

2 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?

0 Answers IGC,

How does the sensitive earth fault protection provided by cbct for motor can help in reducing the size of cable used to supply the motor?

1 Answers

What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?

0 Answers

- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it

0 Answers

why is control bus bi-directional?

0 Answers

What is the efficiency during maximum power transfer?

0 Answers

In power point wiring,often,we use less size of earth wire compared to phase & neutral wire and we use big size pin in pug top. how is it justified? can we use small size cable for earthing?

3 Answers HAL,

kindly tell me how the load on generator increase by just increasing the fuel of prime mover, as if for exampple 20 MW gen set is synchronized the load ramps from zero to 20 MW gradully and during this procress only fuel of prime mover increases. Which thing determines the load on generator with respect to fuel

4 Answers Birla,

How to calulate Locked rotor amper(LRA) for compressor type motors?

0 Answers MAF Dalkia,

how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????

0 Answers

when giving a supply to wounded coil it will get magnetised, but the same is not if it is not wounded on a core..and it is getiing short....why.......

3 Answers

what is the rating of boiler?

4 Answers

For more Electrical Engineering Interview Questions Click Here