Answer / sss

To synchronise two or more generator it's frequency , phase sequence and terminal voltage should be same. ...

Answer / k.prakashchandra

Size , capacity do not matter ?

Answer / e.subhash

If a.C generator means

The following condition should be same before synchronizing the generator (whatever it may be it's size)
1) bus voltage and machine voltage
2) bus frequency and machine frequency
3) bus and machine phase sequence
4) phase angle

The following method is using for synchronizing.
1) dark lamp method
2) bright lamp method
3) synchroscope method

Answer / tasawar abbas suddle

When I sync. the two more than generator we must knowledge of the generator like as its frequency, phase seq, voltage magnitude & phase angel. and its capacity is also same.

if these generator capacity not same then when i start the generator will give the power to the system the other generator is small when big generator give the power to system and the other small generator will absorbed the power and it work like as motor.
and the second small generator will also absorbed power there is no benefit

Is a induction motor rotate by back emf ? If not , then how it is rotate ?

1 Answers  

---

In our plant we are having 6.6 v motor wih MV drive running frm last two years.udenly at some speed motor getting vey vibrations what is the problem

2 Answers   ITC Infotech,

---

my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.

3 Answers  

---

how we can do the insulation on secondary of ct explain and so that tan delta will within limit

0 Answers  

---

What is depreciation factor?

0 Answers   HCC,

---

Differance between power circuit and control circuit

3 Answers  

---

why there is a humming noise in transformer

6 Answers  

---

Why the field rheostat is adjusted such that the voltmeter reads 380V

0 Answers   SRM University,

---

use of automatic voltage regulator & input voltage of it?

1 Answers  

---

Q-1 what are the structural and operational difference between a distribution and a power transformer? Q-2 what is skew in motors? Q-3 draw equivalent circuit of transformer Q-4 explain with phasors how pf is improved with loading in induction motors Q-5 DIFFERENT METHODS OF CABLE LAYING(interviewer asked if i heard new chemical based earthing system next) Q-6 pi model of medium length trans line Q-7 v/f control?why Q-8 vacuum circuit breaker operates in?

1 Answers   Vijai Electricals,

---

in fuel level controller what is MOV please define.

2 Answers  

---

What is the diffrence between an ELCB(earth leakage circuit breaker) and RCCB(residual current circuit breaker)?which has higher degree of safety and why?

2 Answers  

---