Answer / engg.furqan@hotmail.com

Field bus is a protol how to communicate field instruments with DCS scada etc..
there is segment protector installed at field side in which number of instruments connected on segment protector (upto 12 instruments connected on 1 segment protector) , from segment protector single pair of wire goes to the DCS where FF linking device communicated number of instruments connected on 1 segment protector .
(Field bus system is use in many industries for reduce cable cost etc)

Answer / mukesh dayama

It is the family of protocols

Answer / rahul

field bus is protocol used by various companies in order to connect controllers or instruments and hmi with control system.

what is difference between RTD and Thermocouple?

2 Answers  

---

steps for installing orifice plate?

0 Answers   Bhushan Power Steel,

---

which type of signal used in instrument?

3 Answers   Emco, Makson, Sail, TATA,

---

how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?

0 Answers   SEWA, Sharjah Electricity and Water Authority SEWA,

---

What are the different modes of a contollogix family processor? How they work?

3 Answers   Honeywell, Siemens,

---

how to tune the closed pid loop?

3 Answers  

---

how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i

0 Answers   KNPC,

---

What is difference between scada and virtual instrumentation?

1 Answers  

---

What is the difference between EPROM & EEPROM.

1 Answers   Sabic,

---

what are the on/off valve precaution?

1 Answers   Reliance,

---

what is the zero elevation and zero supresstion in level measurement, how can use it?

2 Answers   GAIL,

---

hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q

0 Answers  

---