Answer / bravo

Cascade control is having two controllers,one as primary and the other as secondary to increase the effective and accuracy of your control system

N:B the output of the primary controller is the setpoint of the secondary

What is the diffirence between Earth and Neutral and What is the required normal voltage between earth and neutral

6 Answers  

---

We do have a problem in the company that is one PT connected to PlC which is mean 1 out of 1 in PLC system we do have the PAHH is 55 mbar and PALL 8 mbar with a timer of 15 sec for the PAHH the problem started when PAHH goes more than the set point which is 55 it reached up to 71 but due to timer doesn't trip . We force it and we checked everything nothing there . We replaced the transmitter problem still there the reading goes more than the 55 bar the range for transmitte is 0- 60 mbar . So we did loop check , aculaizing valve , wiring all are okay . What the possible causes for this ???

2 Answers   National Petrochemical Company,

---

What is DCS and PLC scanning time?

5 Answers  

---

why magnetic flow meter is not used in thermel power plant operation

2 Answers   JK Paper,

---

please send the sample qustion paper for iocl written test ..

0 Answers   IOCL,

---

---

what u mean by speed control in turbin? how it was working?

2 Answers  

---

tell about various protocols used in different plcs

3 Answers   Emerson, Samtel,

---

pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.

0 Answers   Siemens,

---

Working principle of vibration sensor?, Type of vibration sensor? , Can we use vertical instead of horizental or vice versa?, if not Reasons?

2 Answers  

---

what is actual difference between pressure Transducer & Pressure Transmitter.

5 Answers  

---

WHY TEMPERATURE TRANSMITTER USED AS WE CAN CONTROL THROUGH THERMOCOUPLE/RTD

5 Answers   Samsung, Thermax,

---

Is it possible to drill additional gland hole in EExd or EExe JBs? What are the points to take care?

2 Answers  

---