Answer Posted / bravo
Cascade control is having two controllers,one as primary and the other as secondary to increase the effective and accuracy of your control system
N:B the output of the primary controller is the setpoint of the secondary
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how can leve transmetter calibate in feild .and also put cv and flow plz .....
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
if my flow is 20000 m3/h than which range of DPT i have to use????
What is three element in drum level?
What are the types of control valves available
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
why fuse block is not used for AI signal?
how to calibrate steam control valve in steam turbine
what will the sending unit in the fuel gauge utilizes?
what effects a surging can produce in the compressor
why we take %i0.0 as input for twido plc
Please asked me How calculate DCS controller memory.
