why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
No Answer is Posted For this Question
Be the First to Post Answer
What is the previous name of Cox's Bazar
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
what is slip what is the use of slip?
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
how can we judge the percentage of load on the basis of temperature differences readings between WTI and OTI in a transformer
Seamless tubes are made by?
total numbers of earthing of a transformer
what should be the megger test report for 11KV cable when meggered with 5KV megger , what is the resistance value we should get
The speed of a dc motor can be controlled by the variation of 1. armature voltage. 2. field current. 3. armature circuit resistance. 4. angle of brush shift. Which of the statements given above are correct? (a) 1,2 and 3 (b) 2,3 and 4 (c) 1,3 and 4 (d) 1,2 and 4
Transformer not operated in dc ! why?
if voltage is not builed up in small generator what will be the reason?
one cable insulation resistance 200 mega ohm. how find 250 meter cable resistance.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)