purpose of hook and bend in reinforcement ?
Answers were Sorted based on User's Feedback
Answer / piyush singh
Purpose of a hook in a beam is to provide anchorage,
A hook gives anchorage same to 16*D of the bar
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / rajasekar
Main reason is to uniformly distribution the load concrete from main reinforcement
Is This Answer Correct ? | 0 Yes | 0 No |
Write short note on construction programme for pile foundation.
How much cement,sand,bricks and water needed for 1square metre brick work?
which one is strong? field weld or shop weld?
what are some possible sources of error in the CBR test?
procedure for preliminary selection of size of column of 5 storey building
) Design a gussetted base for a column section consisting of one sc 250 with two cover plates 300 x 25 mm carrying an axial load of 2500 KN. The S.B.C. of soil is 250 KN/m2 and the permissible bearing pressure on concrete is 4000 KN.
Cement coefficient used for Solid and hollow concrete blocks
Factor of safety for steel should be based on its yield stress or its ultimate stress and factor of safety for concrete should be based on its ultimate stress or its yield stress?
What in your past experience or education prepares you for the position for which you are applying
how many spacers we need for 1 ton reinforcement? aprox.
WHAT WII BE THE WATER ABSORPTION POWER OF WOOD ?
How to calculate quantity of cement , sand and granite from concrete mix ratio and volume of work