why capictor in micro or in nano why cannot it in kilo or megha?

Question Posted / arshad khan

2 Answers
8650 Views
ISRO, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why capictor in micro or in nano why cannot it in kilo or megha?..

Answer / himanshu garg

because capacitance is directly depend on area of plates and if we increase capacitance to kilo, it will increase the area many times which is incompatible to design

Is This Answer Correct ?

19 Yes

1 No

why capictor in micro or in nano why cannot it in kilo or megha?..

Answer / david vk2cz

The unit of capacitance is Farad. Rightly or wrongly 1 Farad is a massive amount of capacitance, often used by Audio enthusiasts in motor vehicles to stablise power. The typical capacitors used in mobile phones, computers, TV and radio equipment are typically 1 millionth (micro) or even less nano Farads and pico Farads. Sure a kilo Farad or a mega Farad is possible, but arguably would have no sensible application outside EW systems.

Is This Answer Correct ?

7 Yes

0 No

Post New Answer

More Electronics Communications Interview Questions

What is electronic?

2 Answers TCS,

where and why do we use stright and cross cable?

0 Answers

What is D-FF? What is the basic difference between Latches and Flip flops? What is a multiplexer? How can you convert an SR Flip-flop to a JK Flip-flop? How can you convert an JK Flip-flop to a D Flip-flop? What is Race-around problem? How can you rectify it? Which semiconductor device is used as a voltage regulator and why? Explain an ideal voltage source? Explain zener breakdown and avalanche breakdown? What are the different types of filters? What is the need of filtering ideal response of filters and actual response of filters? What is sampling theorem? What is impulse response? Explain the advantages and disadvantages of FIR filters compared to IIR counterparts. What is CMRR? Explain half-duplex and full-duplex communication? Which range of signals is used for terrestrial transmission? Why is there need for modulation? Which type of modulation is used in TV transmission? Why we use vestigial side band (VSB-C3F) transmission for picture? When transmitting digital signals is it necessary to transmit some harmonics in addition to fundamental frequency? For asynchronous transmission, is it necessary to supply some synchronizing pulses additionally or to supply or to supply start and stop bit? BPFSK is more efficient than BFSK in presence of noise. Why? What is meant by pre-emphasis and de-emphasis? Explain 3 dB cutoff frequency? Why is it 3 dB, not 1 dB? Explain ASCII, EBCDIC?

3 Answers DRDO, Electronics,

Pl. Brief about DNC.

0 Answers ARDE,

What is optical fiber?

6 Answers CTS,

i want model questions which will be asked in hindustan aeronautics online test for the post of managenent trainee

0 Answers Flextronics, HAL, NIC,

processors and periferals are coonected by PPI,what is meant by PPI?

6 Answers

What is meant by retrace time?

0 Answers

plz post the ne questions for electronics engg interview