For M25 concrete ,what is the maximum compressive strength
at 28 days ?
Answers were Sorted based on User's Feedback
Answer / suresh kumar
150*150*150 cube mould area OK
Grade of m25/
Target strength FCK+1.65*s
S. Is standers show in is 456
20 mm agg.
OK.
Formula is. 20+1.65*4
25+6.6 =31.6 n/sq mm
Is This Answer Correct ? | 10 Yes | 1 No |
Answer / suresh s sonone
Design mix is M25,so target mean strength is fck+4.
so it should be 25+4=29 -N/MM.sq after 28 days
Is This Answer Correct ? | 12 Yes | 4 No |
Answer / frankstein
Definetly it's 25n/mm2
As we know that its M25
Is This Answer Correct ? | 0 Yes | 4 No |
Pls provide me with the calculation or codes related to de- shuttering of flat slabs
Factor of safety for steel should be based on its yield stress or its ultimate stress and factor of safety for concrete should be based on its ultimate stress or its yield stress?
How to calculate the quantity of brick or mortar in m3. like in 1m3 brick =....no. .......mortar=....m3
What is specific gravity & how it is calculated
How is make concrete cube?
How to calculate the Quantity of Steel for Footing?
I have certain queries, please help to solve. a) length of pile bore is 4m.excavation quantity will be area * length where area will be pi/4 * dia*dia. Is this right? b) It is a single reamed pile of 300m dia and reamed dia is 750mm. can any body help me to calculate excavated quantity of this bulb(reamed section),, concrete quantity in bulb with showing the formulas to be used?
Requirement of cement, and steel 1:2:4 ratio concrete in 1128 Sqft area(Cement No of bags, steel in Kgs)
how to calculate freeboard in under ground water tank and technical details
What are the techniques to measure road difference?
1) what is the seewage discharge per person per day taken for design purpose as per IS codes? 2) how to convert gauge to MM like if we measure 18G as our door frame then how much is it in MM ? 3) how much binding wire is required ti tie 100kg steel ? 4) while making rings in steel reinforcement , whether the corners of rings are deducted to take out cutting length ? 5) how much carbon content should be there in steel used for construction purpose? 6) what are fe415 & fe 500 and which bars are used in general civil works?
how to calculate the quantity of cement,sand and aggregate when the ratio of mixing is 1:2:3
0 Answers Ajnara Group, Assosa University,