what are different types of cables used in instrumention

how to calibrate a level transmitter online ( rosemount )



what are different types of cables used in instrumention how to calibrate a level transmitter onl..

Answer / aswin

Mostly we r using F type and G type cable in instrumentation.
F type is individual and overall shielded.G type is over shielded.
Namely divided two type.Signal cable and control cable.signal cable carry 24vdc plus 4-20ma(AI/AO) . But control cable for DI/DO.24V DC,230AC,220 DC.Cable tray root also diff for diff signal.

Is This Answer Correct ?    23 Yes 1 No

Post New Answer

More Instrumentation Interview Questions

Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows

0 Answers  


what is the analog input , analog output , digital output, digital input geven to the MSSV , CBD, IBD , START UP VENT , BOILER FEED PUMP , AOP, CEP , ETC

1 Answers   Bharat Biotech, TATA,


Different between control valve and mov

2 Answers  


what is the process to make control schematic ?

0 Answers  


How can i solve the problem of ROSEMOUNT 5300 guided wave level transmitter of full range? For more clearfication , another guided wave level transmitter VEGA brand have the same problem and i solved it by drain the champer from water and make "false signal suppretion" from transmitter push buttons it's configuration to tell the transmitter to avoid any built-up signal ,,, so my question how can i avoid the problem that rosemount read full range while the champer empty or any other ????

1 Answers  






Why do we use 24V DC supply in instrumentation? What are its merits and demerits??

1 Answers   JSW, MJPRU,


steps for installing orifice plate?

0 Answers   Bhushan Power Steel,


Why we use 250 ohm resistor in series with HART protocol communication?

13 Answers   Chemtrols, Instec, Sabic,


What skill/s does the Instrument Technician has?

6 Answers  


Troubleshoot to the device level basic process control systems given the Process and Instrumentation Diagram?

2 Answers   Chettinad, HPCL,


how works encoder in plc

0 Answers  


Dear sir i m presently working in power plant nd my question is if any pump give flow 18tph then how would i know that how much range flow tx installed their flow line for flow measurement plz give me ans

1 Answers   HPSL, Infotech,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)