Answer / sk abdul halim

Boiler furnance pressure raised & damaged the boiler if ID
Fan is not functioning.We can not run boiler without running
ID Fan.

Answer / devinder singh

Boiler furnace pressure raised and start back firing and it is cause of furnace blast.

Answer / vellaisamy

if ID FAN ON BOILER NOT FUNCTIONING, FURNACE PRESSURE WILL RAISE AND BYPASS DAMPER WILL OPEN IMMEDIATELY ASPER THE BOILER'S SAFETY INTERLOCK EXECUTION.SO THAT, THE BOILER WILL BE SAFE, WHERE AS BOILER EFFICIENCY WILL BE LOW BECAUSE OF NO HEAT EXCHANGING IN THE COMBUSTION AIR AND FURNACE DRAFT ALSO WILL NOT PERFECT.HENCE BOILER CAN RUN WITHOUT ID FAN WITH LOW LOAD.

Answer / sheik nasir hussen

First of all Boiler willn't start without ID FAN due to Boiler interlock if by bypass this logic we start the boiler then draft can't be set without ID FAN Boiler will be trip with furnace draft high.if this logic also bypass then furnace will be pressurised before reaching required amount of air flow for combustion &proper combustion willn't occure which will damage the furnace tube and also there is a chances of furnace blast.

How do you consider that you can improve and what assistance do you need to achieve this

0 Answers  

---

What is droop.

2 Answers   Dhampur Sugar Mills, Elaf,

---

why drum level falls when one of the running coal elevations tripped?

3 Answers   APGenco,

---

why seal air fan is used and where it is used and where is suction taken from

7 Answers   Bhel, ETO,

---

.What is drip and drain.

2 Answers   NPTI,

---

what is turn down ratio

4 Answers  

---

Boiler capacity is 5ton, what will be the feed water tank capacity?

11 Answers   dscl, Indiabulls, Krest, TCS,

---

In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,

---

What are the motors used in a thermal power plant? (With type and ht/lt) What voltage levels are used in a thermal power plant?

2 Answers   OPG,

---

What is the use of NULL meter on AVR panel

5 Answers   Power Plant,

---

why the Steam Turbine(20MW)center line and gear box center line not in same elevation during coupling alignment ?

3 Answers   Greenesol Power Systems,

---

why airtel use + 24 volts and other operators use -48 volt

0 Answers   ABC, Airtel, INDUS, Reliance,

---