i have been tasked with a design of protection, metering
and control(PMC) relay panel extension to accommodate all
PMC relays.There is an already existing panel where this
one will be built.What are the design aspects for this kind
of project? thank you.
No Answer is Posted For this Question
Be the First to Post Answer
At 765Kv, I have seen the use of PT at line side for metering and CVT for protection, although as far as my knowledge is concern, PT at this voltage level will have huge loss and more cost as compared to CVT as CVT can also perform same function of Protection and Metering? So my question is why use PT and not CVT for metering and protection in order to reduce the cost.
Will a bulb glow if we connect it between the phase and earth instead of earthed neutral?
how to calculate unit consumption on 3phase 380-415 v0lt kilowatt motor eg ( 55kw,380v,3phase 50-60hz)
Why does not AC excitation use in rotor of AC Generator instead of DC excitation?
please give some hindalco placement papers for written exam
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
0 Answers Jindal Steel and Power,
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
what is the difference b/w conductor and semicoductor
Why is negative feedback invariably preferred in closed loop system?
tell me about sf6 breakers
what are cable earthing and bus earthing trucks?when and where they are used?
What is the advantangeous over SFU (switch fuse Unit) & FsU (Fuse Switch unit) which one is better & application of Both?