For a 6.6kV Motor it is recommended to do megger test with
500 V d.c and not more than 5kV d.c but the Hi voltage
withstand test should be performed by 12kV AC. Why the dc
voltage test should be limited but AC voltage withstand test
could be with such a high voltage?
No Answer is Posted For this Question
Be the First to Post Answer
what is the transformer
what are the different types of transformers in present? which transformer is efficient?
Circuit diagram of tube light without starter using electrical choke
How to take the Vector Group Test in Transformer? What is the purpose of doing Vector Group Test?
Pl. brief about break-down maintenance of machine tool.
What do you mean by eddy current loss?
transform oil how going to act like ainsulation purpose
what is the working principle/operation/theory of 3-phase rectifier power transformer used in cold rolling mills.
For single phase(phase to neutral) having potential difference 230.in three phase(phase to phase)we have 440V HOW...?
how tubelight circuit is connected and how it works?
how can i reduce sparking without stepdowning the voltage
I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase), before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???