Anybody know how to create a ladder programme for power switch in TV remote without using counter... ie TV can be turn on and turn off using single push button switch... on pressing the switch first time TV turn on and hold the on state till i press the switch again, and after TV turn off.

2 Answers  

---

Why 4-20mA SIGNAL IS PREFERRED OVEA A 0-10v signal?

5 Answers  

---

when an eddy current probe is installed inside of a turbine or compressor in case of probe problem same as:crash of head of probe,changing the scale factor because of low measuring gap(physical gap is ok(example=1.14mm)but voltage is reduced(example=-6 volts),is any way to check the probe,when the ohm of probe is ok.thank you,(Karim Tavakoli)

1 Answers  

---

Why integral control mode call Reset controller?

1 Answers  

---

What is the difference between HMI and SCADA?

2 Answers  

---

what is the criteria to decide conductor size of a cable ?

0 Answers  

---

hi i want sov loop cheak from consol to field the operater given status to sov still no change, but MR room to sov ok so whats a problem and alreasy cheak all conection ok ?

2 Answers  

---

how to calibrate steam control valve in steam turbine

0 Answers  

---

what is the PID controller?

1 Answers  

---

Which of the following instruments consumes maximum power during measurement?

3 Answers  

---

What is Span Error

0 Answers  

---

What are primary elements of measuring pressure?

0 Answers  

---