1.why motor rating in kw instead of KVA?
2.why alternators rating in KVA instead of KW?.
3.why transformer rating in KVA instead of KW?.
Answers were Sorted based on User's Feedback
Answer / rabindra kumar
because motor gives mechanical power as output, where as transformer
n alternator give electrical power as output.
Is This Answer Correct ? | 5 Yes | 3 No |
Answer / jagu
Transformer is independent of pf.Hence the transformer rating is always expressed in KVA.
In Motor the pf is dependent on percentage loading & hence expressed in KW.
Is This Answer Correct ? | 0 Yes | 0 No |
All ac sources are rated in kva where alternator
&transformer and all ac loads are rated in kw
where motor
Is This Answer Correct ? | 0 Yes | 2 No |
Answer / ritika
motor manufacture ki marji.
alternator manufacture ki marji.
Is This Answer Correct ? | 4 Yes | 11 No |
Answer / prasanna
becoz iron losses depends on voltage and copperlosses depends on current.....so the motor rating is in KVA
Is This Answer Correct ? | 1 Yes | 9 No |
what is the difference between oil surge relay and buchholz relay.
explain remenance . differentiate high remenance type ct & low remenance type ct
what is buffer resistance starter.?.What is the working principle and where it is used..?
what is ps impedance test
we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?
0 Answers Afflatus Grauver Pvt Ltd,
what is the ranje of HT cabel and LT Cabel.
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
fuses rated by amperes but not power,why?
why in US MAINTAIN 60hz,110volts when compared with 50hz,220v in india
What is mean by ideal infinite bus? Why it is required to consider in fault short circuit calculations?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
explain single phase series motor