Defference between tapper & ovality

Question Posted / akki.pandit04

Answers were Sorted based on User's Feedback

Defference between tapper & ovality..

Answer / sukhendu bhattacharjee

TAPER OF BORE IS OUT OF CYLINDRICITY ( ALONG THE LENGTH OF
THE BORE)AND OVALITY OF BORE IS OUT OF ROUNDNESS (I.E. BORE
IS ELLIPTICAL).

Is This Answer Correct ?

10 Yes

3 No

Defference between tapper & ovality..

Taper: Concentric about its axis.
Ovality: Eccentric about its axis.

Is This Answer Correct ?

9 Yes

2 No

Defference between tapper & ovality..

Answer / rajput

tapper is angle or degree & ovality is shaft outness

Is This Answer Correct ?

5 Yes

3 No

More Mechanical Engineering Interview Questions

how to guess size of hole according to size of bolt,say M12?

Given a cutaway isometric view of the steam turbine.

Why required store to Factory?

Explain enthalpy.

WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C

What are the factors that can affect the factor of safety selection?

Why stainless steel is corrosion resistant?. What is stress corrosion cracking?.

What is the principle of a pump?

How differential gear boxex work?

what is the three phase induction motor? what is difference between motor used in household instruments and induction motor?

y the unit of torque Nm not called as joule

How we can increase the efficiency of boiler without creating any effort

For more Mechanical Engineering Interview Questions Click Here