What is the difference between basic hole and basic shaft ?

0 Answers  

---

how to design a crankshaft?

0 Answers   TATA, Tata Motors,

---

IN THERMAL POWER PLANT WHY WE ARE USING SINGLE SHAFT FOR THE COUPLING OF HP,IP&LOW PRESSURE TURBINES....WE CAN USE INDIVIDUAL SHAFT FOR EACH TURBINE....?

2 Answers  

---

What are you going to inspect or check when you open the crankcase?

0 Answers   RRB,

---

how we can calculate the air consumption of any system.

0 Answers  

---

hey have you knw the GI sheet thickness as per gauge?

2 Answers  

---

difference between the construction of small and big diesel engine

1 Answers  

---

Where is the maximum temperature in refrigeration cycle? a.Between evaporator & compressor. b.At Compressor c.Between compressor and condensor. d.At condensor

12 Answers   HAL,

---

how to check quality of steel?

0 Answers  

---

What is the torque required at M6, M8, M10, M12, M14, M16, M18, M20, M22, M24 Bolt or give me any chart for this?????????

4 Answers  

---

i just wanted to ask that what should one do to clear all the concepts a mechanical engineer needs to have cleared,this not only includes the concepts of each and every semester of his engineering course, but also the basic laws and fundamentals of physics(that required for Mechanical engineering).I am a third year mechanical engineering student and i am very keen to know about the above question. somebody please help me.

1 Answers  

---

What is ferrite?

0 Answers  

---