we have earthmat at 110KV substation.we would like to take earth resistance.b

we have earthmat at 110KV substation.we would like to take
earth resistance.b some says that by connecting earth megger
terminals (C1,P1) at middile point of earthmat (at riser)
will cause voltage gradient at other earthmat nods and dont
get exat earth resistance.when connecting at end nods will
get exat value . is it correct .please explain

Question Posted / manu

0 Answers
2232 Views
TNEB Tamil Nadu Electricity Board, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%

0 Answers

why control circuit voltage always chooses to be 110v and 220v? and in where it is 110v and 220v? and in where it AC and DC?

2 Answers

why using transformer and thyristor switch in 3 phase apfc panel

0 Answers Reliance,

What is the working principle of ceiling fan?

6 Answers Indian Navy,

how does an encoder work???

0 Answers

Can you explain the phase displacement between primary and secondary of power transformer of any vector group(for ex)?

1 Answers

Explain marx circuit.

0 Answers

How can calculate the efficency of the rectifier. input 240V AC, current 5 amps,P.F 0.98, Output is 54 V DC,62.6 A.

10 Answers

what is the earthing condition between earth & neutral.

6 Answers ABB,

Why hydropower is called renewable source of energy?

0 Answers

what is bus duct and what is differance between bus duct and bus bar

6 Answers

Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.

0 Answers ABB,

For more Electrical Engineering Interview Questions Click Here