why using transformer and thyristor switch in 3 phase apfc panel
No Answer is Posted For this Question
Be the First to Post Answer
how can check the resistance of battery contact?
I find that underground strip-armoiured,4core,LT PVC cables in an earthed power distribution sytem are occasionly found in charred condition-with no trace of it except ash. Is this because of no proper earth connection/continuity (giving rising to high armour resistance)in the joint enroute or because of insufficient capability (again due to high armour resistance)of cable-armour to carry fault current or due to neglected /unprotected overloading of the cable or due to high armour currents caused by power thefts where only phase(s) are unauthorisely tapped & at the point of poer consumption earth terminal is established by burring underground a not so good earthing rod (or using an underground water pipe for the purpose)
Ps Explain YWY,AFWY Type Cable
In Plumbing services What are accessories we consider for a bathroom?
Define norton equivalent circuit?
Which standard we are following earthing resistance test
What is the difference between Isolator & Load Break Switch?
what is the difference between neutral and earth????
defination of transistor controlled series capacitor
what instruments used for measuring of inductance and capacitance.
Differentiate between ideal and non ideal current sources?
what will happen if secondary of potential transformer (220kv/110volt) of any metering core or protection core (cables) of any phase got earthed??