What is the Steel bar spacing formula for Concrete Slab?
Answers were Sorted based on User's Feedback
Answer / prashant
it is depend upon the type of bar(like10mm bar,8mm bar)
SPACING=((area of one bar)*(width))/(area of rienforcement calculated)
where,
width=generally 1000mm,
area of reinforcement is calculated from design load,
and area of one bar is calculated from dai of bar which we havw taken(usually 10mm and 8mm fro slab)
Is This Answer Correct ? | 105 Yes | 18 No |
Answer / omar
(Area of steel-required- /1000) = (Area of one steel bar/S)
find S
then:
the answer will be ΦX/ each S
Is This Answer Correct ? | 19 Yes | 7 No |
Answer / babu
Depends upon structural drawings, minimum 6" square gap
Is This Answer Correct ? | 21 Yes | 24 No |
Answer / somnath deore
IT IS DEPENDS UPON THE SPAN.FOR LONG SPAN, SPACING WILL BE
6"& FOR SHORT SPAN SPACING WILL BE 7" TO 8".
Is This Answer Correct ? | 13 Yes | 16 No |
What is M40 _ TOR - EQ and B.F.S
0 Answers Odisha Hydro Power Corporation, Ramky, Simplex,
what is zone a n zone b?why the spacing of ring in zone a less.n zone b high?
how many cement in cubic feet of 40 kg bag white cement.
compressive strength of country bricks in india
What is the civil engineer
how to calculate the crushing strength of cement concrete paver blocks 100x100x60 mm thich.
pointing raju,ayesha says"he is the son of my mother's brother's wife". how is ayesha related to raju?
which member is very strong (strength) after the cross- section area is same, pipe section or solid rod section ? no that's not my question, my question is why pipe section is strong ?
In the present situation of ban on mining sand from rivers,can we go for formation of earth dam filters viz;Horizantal sand blanket,inclined chimney and filters under rivetment with crushed rock sand of 6mm down size.If so what are the specifications and is there any codal provision for its authentication?
While painting,if the gypsum is the first coat to seal holes on wall,It said to have tendency get away with all other coat. What is the solution on that?
which software better design in structure design or Rcc design(STAAD PRO,TEKLA STRUCTURE)
how do you calaculate the total steel quantity of an rcc building using thumb rule?