Answer / sudhakar g

If we take the LT panel incoming of the breaker is 1600A
and the transformer rating is 2000KVA.
We have to select the cable for that t/f to incoming
breaker in LT panel
400Sqmm AL cable carry 315A (POLYCAB) then we go for 6Runs
from T/f to LT panels
It is simple to cable runs of the T/F to I/c of the panel

which surface is suitable for NEUTRAL GROUNDING ?

1 Answers   NTPC,

---

What is the role of the 50 STUB protection at a GIS 400KV substation with SIEMENS protection relays?

0 Answers   Power Plant,

---

What is rotor angle stability?

2 Answers  

---

Earth leakage relay basic knowledge principle

0 Answers   Radiant,

---

What is the different between digital phase converter and ordinary phase converter?

0 Answers  

---

im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar

0 Answers  

---

What does Transformer vector connection Dy11y5 means?

1 Answers  

---

there is a power transformer 66/11kV in delta-delta connection has 5 feeder coming out from the secondary side. One of the feeder in it normally loaded (loaded than other feeder)and this feeder usually trips with double OCR causing the bank transformer to trip. Now if the load of this feeder is put on other transformer then that no problems occurs on that transformer or the load. However normally all the test(IR, PI, short ckt, open ckt,grounding test and other ) has been conducted for this but evertything transformer..... I am not geting what is the actual problem...

2 Answers  

---

why we not using 230kv directly why we are stepping down and then stepping up

2 Answers   Siemens,

---

Which transformer is suitable for 220/11 kV, 60 MVA, distribution , Y-Y or D-Y or Y-D, give comparison for the same.

3 Answers  

---

What is the method to calculate the capacitor bank rating for say 50 KW load and how do we connect each capacitor to busbar??

4 Answers  

---

Why we can't start a tube light without a starter(choke) and an inductor?

1 Answers  

---