What is difference between ON delay and OFF Delay Timer?
Answers were Sorted based on User's Feedback
Answer / guest
ON delay timer is after the time period ( timer value given
by user)enable the out put..
off delay time is after the time period (timer value given
by user) disable the out put..
Is This Answer Correct ? | 65 Yes | 18 No |
Answer / andy
On-delay:
Output contacts change state after input signal is present for selected time. Output contact can be normally open or normally closed. Contacts return to shelf state after input signal is lost.
Off-delay:
Output contacts change state when input signal is applied. Contacts return to shelf state after input signal is lost after a selected time.
Note:
Outputs can energize or de-energize devices after timing sequence since contacts can be normally open or closed.
Is This Answer Correct ? | 8 Yes | 2 No |
Answer / dgfdhgfg
On-delay timers
With an on-delay timer, timing begins when voltage is applied. When the time has expired, the contacts close
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / s.k.m
On delay timer is activates the function against timers NO contact after the settled time.
Off delay timer is deactivates the function against timers NC contact after the settled time.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / milan virani
On Delay timer is when we set 5 sec in timer so when we give supply to timer
Timer works for 5 sec and after 5 sec the contacts of time change over
OFF delay timer if we set 5 sec then if we cut the input the contacts of timer change over after 5 sec frm when we cut the input of timer
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / andy
On-delay:
Output contacts change state after input signal is present for selected time. Output contact can be normally open or normally closed. Contacts return to shelf state after input signal is lost.
Off-delay:
Output contacts remain in shelf state when input signal is applied. Contacts change state after input signal is lost for a selected time.
Note:
Outputs can energize or de-energize devices after timing sequence since contacts can be normally open or closed.
Is This Answer Correct ? | 0 Yes | 5 No |
Give two basic sprrd control scheme of DC shunt motor.
At the time of 1st charging of transformer, there were huge inrush current, so why at that diffrential relay are not operated? Why?
what is the acceptable insulation resistance for motor/transformer?
2 Answers Reliance, Tata Motors,
how to calculate the watts from the tr
What is the output voltage of a DG set.
how we have to calculate the short circuit current for 33/11kv 2mva, 7.5% Z, Transformer primary side breaker and secondary side breaker short circuit current for both sides?.
In a company has been installed an analog amperemeter, this company was suplied by generator X, there is no problem in the ampere meter, rigth now this company's supplied by generator Y then the pointer in amperemeter vibrating. What happened? Why? Thank's
Lt motor sfu flashing reasons?
What is trickle charging system?
Your B.tech marks is being given in CGPA grade. How is it calculated?
I am in last year of Engineering.I want to apply for ONGC on GATE based score.They require Certificate of Competency as Electrical Supervisor.How can i get this certificate so I can apply for AEE(ELECTRICAL) in 2016
what is difference between VAT & CST