What is difference between ON delay and OFF Delay Timer?
- 7 Answers
- 51093 Views
- I also Faced
- E-Mail Answers
Answer Posted / andy
On-delay:
Output contacts change state after input signal is present for selected time. Output contact can be normally open or normally closed. Contacts return to shelf state after input signal is lost.
Off-delay:
Output contacts remain in shelf state when input signal is applied. Contacts change state after input signal is lost for a selected time.
Note:
Outputs can energize or de-energize devices after timing sequence since contacts can be normally open or closed.
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
aternator every parts and its working
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
List of equipments required foe industrial repair lab.
what is the difference between fault current ant short circuit current?
what is gridrotor resistance starter
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
Is there chopping current in resistive circuit
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?
In convertor can we use rectifier thyristor in place of invertor thyristor with explain.
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
