i/p converter always for supply pessure from 3~15 psi only !! And from where t

i/p converter always for supply pessure from 3~15 psi
only !! And from where this converter bleed the air.

Question Posted / nayef

2 Answers
5390 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

i/p converter always for supply pessure from 3~15 psi only !! And from where this converter bleed ..

Answer / sushil d. jambhulkar

IN I/P THERE IS A FLAPPER & NOZZLE SYSTEM,CONVERTER BLEED
THE AIR FROM NOZZLE.

Is This Answer Correct ?

6 Yes

0 No

i/p converter always for supply pessure from 3~15 psi only !! And from where this converter bleed ..

Answer / vinoth

I/P converter gets the bleed off air from the Air compressor
unit.
From air compressor unit, air will go to a regulator
from where the Pneumatic air is supplied to the I/P converters.

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

WHAT IS A SYMPTOM OF FAULT WITH THE SPAN OF AN INSTRUMENT? 1)ZERO-POINT AND 100% ARE CORRECT BUT NOT A MID-RANGE. 2)ZERO-POINT IS CORRECT ,BUT 1005 INPUT IS NOT GIVING 100% OUTPUT. 3)LINEARITY PRBS. 4)1005 O/p IS CORRECT BUT ZEO POINT IS WRONG.

1 Answers Reliance,

In electronic board one fuse(rating 230v,100ma)showing 2.5 ohms with multimeter,then the fuse is healthy or not.

4 Answers

What is seismic transducer?Where it is used?

1 Answers

What are the application of bernoulli’s theorem?

0 Answers

how will you segregate the alarm levels in alarm management system during factory Acceptance Test

0 Answers

what is linerity and non-linearity?

2 Answers

if we have 450 mm heigth boiler drum level ,so what is span & zero value for a dpt tranmitter