Answer / morsli

you have in positionner the direct and reverse action ,you have only to commutate to direct action means when the signal fron the controller rise the out put of the positionner will rise also ,in same direction 4-20 ma signal to i/p positionner the signal will be 3-15 psi from the positionner..
but in reverse action when the signel from the controller increase the out put of positionner decrease reverse action 4-20 ma signal to i/p positionner the signal will be 15-3 psi from the positionner.
sincerly

What is voltage free(wet) and potential (dry) contact?

2 Answers  

---

how can we understand about dcs "bailey infi 90 dcs system" . how its work how signal come from field how it process and how o/p creative by controller. how its cards work.the bsic principle of working of dcs

1 Answers  

---

what is the usage of QDV & VOLUME BOOSTER.

2 Answers   ADMA OPCO,

---

what is temperature compensation?

1 Answers  

---

How we calculate orifice plat size???

0 Answers  

---

---

what is the difference between plc and pc?

5 Answers   ADI, NFCL, Wipro,

---

how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?

0 Answers  

---

How to carry out hot loop checking of closed loop pf temperature control valve & temperature transmitter?

2 Answers  

---

why use to 250 ohm for hart protocol and why hart communicator not communicate without 250 ohm 

4 Answers   OMV,

---

why we use the 4-20 mamp signal used for transmitter.

5 Answers   Tecnimont,

---

how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744

0 Answers  

---

what is linerity and non-linearity?

2 Answers  

---