What is the principle of a Pressure gauge?

Answers were Sorted based on User's Feedback



What is the principle of a Pressure gauge?..

Answer / vikas panwar

Pressur Gauge working on Hook's Law.

Is This Answer Correct ?    12 Yes 0 No

What is the principle of a Pressure gauge?..

Answer / faiyaz

working principle of pressure gauge is hook law

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More Instrumentation Interview Questions

What is difference between profibus and modbus communication

2 Answers   GMR,


how to measure temperature from resistance of rtd?and how to measure temp from voltage of thermocouple?is there any formulas?

3 Answers  


how to change 4 wire rtd transmitter into a 3 wire rtd transmitter? as our transmitter is working for 4 wire rtd, what should do for working on 3 wire rtd transmitter

1 Answers   HHJ,


Why we using 250ohm resistance during lab calibration and why not using in field in one plz define deeply???

1 Answers   Cisco,


If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?

10 Answers   QAFCO,






In a class of 150 students, 40 passed in Social Studies, 90 passed in Science and 30 failed in both the subjects. vi)How many students passed in at most one subject among Science and Social Science?

7 Answers   CAT, CGI, Cipla, KHK, Visa,


Level in tank under vacuum (Ex: Condensate Tank of Power Plant)is measured using D. P. type level transmitter. Tank is subjected to vacuum of 755mmHg. Is it possible to fill wet leg ( i.e. leg connected to top of vessel with low point of D. P. xmtr) with water?. Are there chances of water getting sucked under vacuum? if yes, what is the solution?

3 Answers  


Why flow/pressure transmitter before control valve?

0 Answers   UPL,


how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.

0 Answers   Adani Power,


How does temperature bath work? How does coil gets heated only by applying some current?

0 Answers   Process Control Technologies,


tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),

0 Answers  


WHEN BOTH WIRES OF THERMOCOUPLE R SHORTED WHAT IS THE OUTPUT THE TEMP ARE 0,30,250,320

13 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)