Answer Posted / vikas panwar
Pressur Gauge working on Hook's Law.
Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
How to check vortex flow meter is in good condition while we do not having calibration setup?
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
all types instrumentation questions want
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
How servomotor controls throttle valve of TURBINE?
What is cut off relay? And why use in PLC and DCS?
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
what is wave length were using ?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
how do we commission inergen system?
Explain the working principle of lvdt?