75kw drive operated motor current fluctuation
from(85-130)ampere.current setting in drive
is 130amp.sometimes motor trip when current
limit cross 130amps.I change the drive. still
current fluctuate between 80-130amps but in
this time motor not trip,current setting in
drive is 130amps.where is the problem?
Answer / mohit punjabi
the motor will not trip because as the user has change an old drive which was of 75 kw with new one so he has to set a parameter in new drive that when fluctated above 130 amps the drive should trip the motor without these parameter setting the new drive will not trip
Is This Answer Correct ? | 3 Yes | 2 No |
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
what is the difference between isolator and circuit breaker
What is the normal earth resistance?
why the all high voltage transformers are in 11kv , 33kv , 66kv, 132kv like that
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
In our factory there is one no. of Series trip HT 6KV OCB. 1. Is it possible to measure CT out put current by 440V Clamp meter? The measurement is required for knowing the exact value of current in CT secondary to set up protection for transformers. 2. plase forward the single line diagram of AMF panel?
Which types of Gases occure when mineral oil burnt
WHAT IS THE DIFFERENCE BETWEEN UNDERVOLTAGE COIL, CLOSING COIL AND SHUNT TRIP COIL OF AN ACB?
Which is the oldest hydropower plant in india?
How check electrical motor winding.
srij i need the relationship b/w KW AND KWH and with an electrical example. plz send if u can?