diff bw range and span?

Question Posted / guest

3 Answers
6297 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

diff bw range and span?..

Answer / ginoop

range =lrv & urv
eg: 50 to100mmwc

span= urv-lrv
eg : span of 50 to 100mmwc
=100-50
ie span=50

Is This Answer Correct ?

4 Yes

0 No

diff bw range and span?..

Answer / r_vaya

Range is operating units of Instruments from lower to higher

Span is the gap between range.

Is This Answer Correct ?

2 Yes

0 No

diff bw range and span?..

Answer / r_vaya

Suppose Transmiter is calibrated at -100 to + 100.
Determining it's LRV =. -100 And. URV. =. +100

Thus in above case :

Range is -100 to + 100
Span is 200

Because,
Span is the gap between LRV and URV
That'swhy (+100) - (-100) = 200 become a Span

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

how can loop single 4-20 ma to two isolation amplifier? i mean i have two isolation amplifier with 4-20 ma input and 1-5 v output.can i done series connection ?

1 Answers

Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?

0 Answers

wht is snap action switch?where it is used?is there any diff between snap action switch and normal pressure switch?

1 Answers ONGC,

IS IT POSSIBLE TO CALIBRATE A LEVEL TRANSMITTER INDICATOR(ABB) USING HART COMMUNICATOR.? I MEAN TO CHANGE FROM ONE UNIT TO ANOTHER WITHIN INDICATOR (EG. INCH TO FEET)...? PLZ NOTE THAT I HAVE MADE THE UNIT CHANGE IN TRANSMITTER USING HART COMMUNICATOR..BUT WHAT ABOUT THE INDICATOR..?

2 Answers

what is output of FOUNDATION FIELD BUS transmitter

0 Answers

kindly tell where orifice,nozzle,air foil,ventury used in flow measurement?

1 Answers

what is the use of glycol filling in seal pot (or) condensate pot in instrument impluse line?

7 Answers

in which application we use bigger size actuator

5 Answers

How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?

0 Answers

what is the role of proportional in process control?

6 Answers OGDCL, Trident,

what is the output of conductivity sensor and PH sensor?

3 Answers

If I want to buy a pressure switch & 3-way valve for hot water application then witch parameter I should consider.

1 Answers

For more Instrumentation Interview Questions Click Here