Answer / khamesra.amit

PD is localised discharge which happens within the insulation because of small air pockets formed during winding insulation is being done in workshop. A Ultra high frequency signal is injected at the terminals which detects the frequeny and magnitude of electrical dischages. These values halps us in dentifying healthiness of insulation of the equipment.

1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?

0 Answers  

---

How i can calculate the cable size for given load,there is any formula,for 3 phase and single phase

2 Answers   Prescient Technologies,

---

How can ignition voltage of light increased with the help of a ballast

1 Answers  

---

If 11 KV breaker on the primary side of a 11 KV/3.3 KV 12.5 MVA transformer can be installed at a distance of 1000 mtrs through a 11 KV cable. If no what are the probable reasons.

1 Answers  

---

what is the difference b/w ATS and HTS?

0 Answers   Mikano,

---

What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.

0 Answers   Kirloskar,

---

List some examples of renewable energy?

0 Answers  

---

how electronic energy meter works?

12 Answers  

---

If OLTC is in manual position there is chance to variation of voltage(Low or High)?

1 Answers   Juniper Networks,

---

How to calculate earth wire load by formula

0 Answers   Caparo,

---

Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.

0 Answers  

---

In a transformer ,when voltage decreases current increases. but this is a violation of oms law.why?

15 Answers  

---