If the design CBR of subgrade is 10% but the material available on site is 30%.w

If the design CBR of subgrade is 10% but the material available on site is 30%.will you compact less(like 90%) where you get desirable CBR(10%).

Question Posted / cumarmani

3 Answers
5218 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

If the design CBR of subgrade is 10% but the material available on site is 30%.will you compact less..

Answer / hitesh kanpariya

No, sometimes material delivered on the site may be different or we can say its natural material so base on that we have to compact it.

Is This Answer Correct ?

2 Yes

0 No

If the design CBR of subgrade is 10% but the material available on site is 30%.will you compact less..

Answer / pranav pachori

NO FULL COMPACTION I.E 90%REQUIRED THOUGH WE CAN SUGGEST TO DESIGNER TO REDUCE THE THICKNESS OF SUB GRADE THOUGH GENERALLY SOIL NOT EXHIBIT SUCH A HIGH CBR LIKE 30% BECAUSE SUCH KIND OF HIGHER CBR BELONG TO GSB MATERIAL

Is This Answer Correct ?

1 Yes

1 No

If the design CBR of subgrade is 10% but the material available on site is 30%.will you compact less..

Answer / rk

For increase the cbr must be added bending material like sand and granular particals for making proper cbr.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Civil Engineering Interview Questions

What is the difference between one-way slab and two-way slab?

0 Answers

after temping in cbr mould keep how many hours mould in water

2 Answers

Explain the advantages and disadvantages of using plastic and timber fenders?

0 Answers

what is c4x light weight cement blocks

0 Answers

What is the diameter of the 3"inch nails?

0 Answers Rohan Builders,

indiploma civil engineering student r studied is456-1978. but in practicial we r using 2000 version i think 1978 version didn't use the student. any openion?

1 Answers

what is escalation?how it is done?

0 Answers Vishal Nirmiti,

neutral axis more than the critical neutral axis then rainforcement in rcc beam belong to over or under rainforcement

2 Answers

why we designed limit state method?

1 Answers

Whr should a joint be located in a beam if the provision of a joint is unavoidable??

2 Answers BMTC,

What are causes of cracks in outside plaster of a building and how we prevent it during constructions?

6 Answers

What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...

0 Answers SIPL,

For more Civil Engineering Interview Questions Click Here