a wire in which bulb is connected there is two terminal when one terminal is

a wire in which bulb is connected
there is two terminal
when one terminal is connected to phase than why the value of
current shock in nutral terminal is max. or large??

Question Posted / ashok mishra

4 Answers
5721 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

a wire in which bulb is connected there is two terminal when one terminal is connected to phase ..

Answer / ashok mishra

because load(bulb) is connected than the value of current increased and the shock is high

Is This Answer Correct ?

1 Yes

0 No

a wire in which bulb is connected there is two terminal when one terminal is connected to phase ..

Answer / k.prakashchandra

If you do not connect neutral to neutral terminal,you have
to receive shock,as the phase is extended to neutral
terminal of the bulb,but it can not be max

Is This Answer Correct ?

1 Yes

2 No

a wire in which bulb is connected there is two terminal when one terminal is connected to phase ..

Answer / ashok mishra

don't mine mr dj but there is a resistance is connected in series with tester and our body acts as neutral and the level of current is too small thats not affect to our body as realize
and as my knowledge there shall be shock at the neutral terminal
and u can show some other answer
knowledge is power

Is This Answer Correct ?

0 Yes

1 No

a wire in which bulb is connected there is two terminal when one terminal is connected to phase ..

Answer / dj

U cant get any shock it is just like a tester when u touch the tester metal body u work like a neutral as well as here in bulb

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

How to calculate cable sizes in sq.mm. with using motor KW? Any formula there?

18 Answers Aswani Properties, BRB Cable, Construction, Hitachi, L&T, Microcool Systems, Nahar, NWPF, Reliance, Renault, Saha Bright Polytech, SGH, TATA, Techno Electric and Engineering, TFIL, Thermax,

what is the technical term when and alternator's prime mover fails.

3 Answers DVC,

how we can save the power ? suppose the electricity board gives 11 kw , but the machine require only 8 kw means how we can save the exese energy

2 Answers

what is the diffrence between single phase and three phase

6 Answers

why one side of tubelight glows after switch off ?

1 Answers

What is the difference between Zero Current Transformer and Core Balance CT ?

1 Answers

Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?

0 Answers IOCL,

Can anyone please give me the parameters , formula needed to calculate the circuit breakers for building services.Thanks

0 Answers Bhel,

what is the significance of tan delta testing?explain the theory?

7 Answers

Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.

0 Answers

why use -48 volt DC power in telecom?

3 Answers

we have 400kv/6.6kv transformer ,it has total 9 taps on HV side with normal tap on tap no 5.when we took the ratio test we observed that ratio was decreasing from tap 1 to tap 5 and was found increasing from tap 5 to tap 9.What is the reason?if anyone have related document then please send me on the email id ankushbahale@gmail.com......plz plz

1 Answers

For more Electrical Engineering Interview Questions Click Here