if i have one capacitor=80 micro farad which correct the unity power factor,bu

if i have one capacitor=80 micro farad which correct the unity
power factor,but i want to make capacitor bank who correct the
power factor.so,how to split this capacitance value?

Question Posted / janki brahmbhatt

2 Answers
4396 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if i have one capacitor=80 micro farad which correct the unity power factor,but i want to make cap..

Answer / mohammad anas

if the connection is 440 valt , and the power factor increses , then what is the value of capacitor used in this circuit?

Is This Answer Correct ?

1 Yes

0 No

if i have one capacitor=80 micro farad which correct the unity power factor,but i want to make cap..

Answer / antaratara ghosh

The split of the capacitor in capacitor bank is completely
dependant upon the connected load of the bus where the bank
is connected... the number of motors and their duty will
determine the number of splits and the value of split
needed..

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

how we do Vector group ,magnetic balance and tap changer test in Transformer?

0 Answers Afcons, BSL, HPL,

Why battery rooms painted with dark colour

1 Answers BAL, MSETCL Maharashtra State Electricity Transmission Co Ltd, Polycab,

What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.

0 Answers

how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)

0 Answers

What is the basic difference between directional and non directional over current protection?

1 Answers

what's the activities of reactor in Buchholz relay?

1 Answers Yahoo,

How do you find HT and LT sides of a distribution transformer only by looking at it from outside?

1 Answers Nespak,

WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB

0 Answers

What is the type of earth fault protection used in battery? explain.

0 Answers PSEB,

Why short ckt does not happen when solenoid coil connected to supply. as its a wire only.

1 Answers Siemens,

we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain

0 Answers TNEB Tamil Nadu Electricity Board,

Where we use 30mA , 100mA & 300mA RCCB ?

3 Answers BEL,

For more Electrical Engineering Interview Questions Click Here