y we use neutral,all r told its used to for closed path..k its a just used to c

y we use neutral,all r told its used to for closed path..k
its a just used to closed path,in a transmission line y we
put same conductor used n both phase and neutral..if we use
less than phase conductor in neutral mean we ll reduce cost
its right r wrong..if we use mean any problem occur in
transmission line..

Question Posted / karthikeyan.p

0 Answers
2005 Views
ME, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

In our homes we place the 5Amps fuse...now in our house only takes 5Amps for all normal conditions ha???

2 Answers Areva, Bajaj, MSP,

Capacitor panel CT is normally fixed on Y phase of the main panel.why???

3 Answers

for a machine R=130 KVA Y=132 KVA B=144 KVA Then what will be the total kva

3 Answers ABB,

Why capacitor bank does not require in DG Set?

21 Answers IBM,

What happen if you keep open the Neutral Grounding Switch in open condition of the HT Generator at starting and again on load if it open then?

1 Answers

What will happen if supply frequency change in Transformer KVA rating ?

1 Answers

why we used to transmitt the power at higher voltage why not at lower voltage

8 Answers

Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com

0 Answers

Technical equations

1 Answers ME,

when i am going to take trail on a 3ph sq.i/m motor 5.5kw, i observed that RPM of the motor is very low as compared to the rated RPM and also it rotates in clockwise in first ON command,and anticlock wise in second ON command. finally i observed that on phase is no available . but iam not clear about, why the motor is rotates in both directions without any phase interchanging.pls answer to my question.

1 Answers

active elements are those which are capable of

2 Answers

Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.

0 Answers ABB,

For more Electrical Engineering Interview Questions Click Here