why only dc is given as excitation...why not ac???
Answers were Sorted based on User's Feedback
Answer / tj
the requirement for the excitation is of constant pole
electromagnet not pulsating pole em, as this only can lead
to pulsating emf on armature.
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / manikumar agcet
If excitation is dc then it is
easy to vary output voltage&
powerfactor.
Is This Answer Correct ? | 5 Yes | 3 No |
how to select the no. of brushes in a lap winding?
How the over load setting for HT Motors calculated-provided in Numerical Relay
0 Answers Damodar Valley Corporation,
how to calculate mf when meter and cTPT detail are given
Lt motor sfu flashing reasons?
IN 6.6KV 3 phase switch gear .i will give 6.6kv to R phase only to earth in during H.v testing (through H.v KIT).what happen remaining phases.how much voltage get remaining phases.why? explain.
Natural frequency of a system gives... 1) nature of transient 2) overshoot 3) oscillations 4) speed of response
In secondary transmission i.e., in distribution side, supply for homes are connected through different phases in order to balance the 3 phase load. But in practical we saw nearby house doesn't have power due to single phasing. But other two phases give supply. How it's possible? it doesn't make "single phasing"?
how unidirectional torque is produced in DC motor?
How to set the relay,,??
0 Answers Megatron Solutions, Nestle,
what happens when dc supply is given to the transformer?
What is skin effect?
what are the tests comes under the type test, what tests comes under routine tests.